lulanda21
New Member
- Joined
- Aug 15, 2011
- Messages
- 16
- Reaction score
- 0
- Points
- 0
- Location
- Griffin Ga
- Vehicle Year
- 1993
- Make / Model
- ford
- Engine Size
- 4.0
- Transmission
- Manual
Ive been trying to install a cold air intake on my 4.0 ranger, Its a el cheapo from auto zone but I have a nice filter.
Anyways, I hooked everything up (truck ran great before) and it was hard to start, and when it started it would idle rough and shut off, but I can unplug the MAF and it idles fine. One of my buddies said that I prolly have a leak so I took it back off and checked everything, and tightend it again and it still runs like crap, It does smooth out a bit when it warms up though....
Any Ides?
MAF, TPS, and the Idle can thingy on the side of the intake are all new also.
The truck has also been tuned up recently.
Anyways, I hooked everything up (truck ran great before) and it was hard to start, and when it started it would idle rough and shut off, but I can unplug the MAF and it idles fine. One of my buddies said that I prolly have a leak so I took it back off and checked everything, and tightend it again and it still runs like crap, It does smooth out a bit when it warms up though....
Any Ides?
MAF, TPS, and the Idle can thingy on the side of the intake are all new also.
The truck has also been tuned up recently.