pintobobster
Member
- Joined
- Jun 30, 2014
- Messages
- 81
- Reaction score
- 3
- Points
- 8
- Age
- 63
- Location
- Washington State
- Vehicle Year
- 1995
- Make / Model
- FORD
- Engine Size
- 4.0L
- Transmission
- Automatic
Just quick question on the led light swap in the dash.
I changed them all (T10 and T5) issue I am have is ABS flashing, the Battery dummy light lite and the 4- low light
But when turning on the dash lights the 4-low goes out but the battery dummy light and the ABS stay lite??
Any one else have this issue and if so what corrected it or what LED bulbs did you use.
I switched those warnings back to Incandescent and the issues went away (I hooked up ABS, SRS, Code reading and got no CEL or engine codes)
What I am wondering is what type (LED) should have been used??
This was on a 1995 Ranger XLT 4X4 4.0L Automatic
I changed them all (T10 and T5) issue I am have is ABS flashing, the Battery dummy light lite and the 4- low light
But when turning on the dash lights the 4-low goes out but the battery dummy light and the ABS stay lite??
Any one else have this issue and if so what corrected it or what LED bulbs did you use.
I switched those warnings back to Incandescent and the issues went away (I hooked up ABS, SRS, Code reading and got no CEL or engine codes)
What I am wondering is what type (LED) should have been used??
This was on a 1995 Ranger XLT 4X4 4.0L Automatic
Last edited: