Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
I can't remember the exact part number, I do know I used a Russell brand piece and it was a common thread. You may find a picture of it still in the original packaging somewhere in my build thread.
Did the ones you use look like this? http://m.summitracing.com/parts/rus-640281 i think the quick disconnect connects to this and it screw into any slave. If thats the case i can reuse the stock line and all
Yep, it looked just like that. I pushed it in and drove the roll pin through and it was done.
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
