• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

dang ole exploder tranny


gunslinger

New Member
Joined
Mar 6, 2010
Messages
3
Reaction score
0
Points
0
Vehicle Year
1986
Make / Model
ford
Engine Size
was 2.3 soon2be 302
Transmission
Manual
newly aquired 94 eddie bauer exploder 4x4,4.0 engine -auto trans....won't shift out of 1st. gear,and shutters in reverse until i give er more gas...any ideas ??, also the fuel gauge doesn't work.. ERRRRRR..:icon_welder:
 


adsm08

Senior Master Grease Monkey
Supporting Member
Article Contributor
Ford Technician
TRS 20th Anniversary
Joined
Sep 20, 2009
Messages
34,623
Reaction score
3,613
Points
113
Location
Dillsburg PA
Vehicle Year
1987
Make / Model
Ford
Engine Type
4.0 V6
Engine Size
4.0
Transmission
Manual
2WD / 4WD
4WD
Tire Size
31X10.50X15
Get a stick.

Most of the time no fuel gauge means bad sender, so a pump will be needed. OE ones are available for around $200. Airtex makes a good one that usually runs about half that.
 

RangerSVT

Oct 09 OTOTM
Article Contributor
V8 Engine Swap
OTOTM Winner
Solid Axle Swap
RBV's on Boost
ASE Certified Tech
TRS Banner 2010-2011
TRS Banner 2012-2015
Joined
Mar 15, 2009
Messages
7,883
Reaction score
53
Points
48
Location
TRS since 2002 - NW KY
Vehicle Year
19962002
Make / Model
Ford
Engine Size
GT-40 5.0L EFI W/AC
Transmission
Automatic
If the trans dont shift out of first it usually either has internal damage, or the electrical plug is not connected, no plug connected means no power to the shift solenoids...Check to make sure the plug is connected to the trans, its right above the shifter linkage, also check on the firewall right above the trans, make sure that connector (trans harness) is connected as well
SVT
 

pwrranger88

Member
Joined
Oct 25, 2008
Messages
404
Reaction score
2
Points
18
Age
35
Location
rhode island
Vehicle Year
1991,1996
Make / Model
Ford
Engine Size
4.0,2.3
Transmission
Manual
have you checked the fluid level in the transmission? the fuel gauge issue could be a bad chassi ground. id check to see if it were a ground before you start randomly replacing parts and waste a bunch of money.
 

bronco_lou

New Member
Joined
Mar 17, 2009
Messages
170
Reaction score
1
Points
0
Location
Columbia, SC
Vehicle Year
1988
Make / Model
Ford
Engine Size
94 explorer 4.0
Transmission
Automatic
If the trans dont shift out of first it usually either has internal damage, or the electrical plug is not connected, no plug connected means no power to the shift solenoids...Check to make sure the plug is connected to the trans, its right above the shifter linkage, also check on the firewall right above the trans, make sure that connector (trans harness) is connected as well
SVT
Shift solenoid controls 3 to 4th shift.
Here is a possible list of problems
1. Improper fluid level
2. kickdown system damaged
3. governor valve sticking
4. intermediate band out of adjustment
5. vacuum leak to diphragm unit
6. vacuum diphragm bent, sticking, leaks

I would look at 1, 5 and 6 first then maybe 3
Louis
 

Sponsored Ad


Sponsored Ad

Staff online

Members online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Shran
April Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top