i just bought some moog eccentrics for my b2 after doing a washer lift ..how do you install these? and also how much body lift can i do without extensions?
The bushing should have the instructions with them... But you pretty much ahve to remove the spindles to get the buggers in as they are what the upper ball joints set in. As for the BL 2 inches is about the max I've seen that did not require extending anyhting and IMO that is a far as you want to go with a BL unless you are putting in a 302.....
no u dont have to remove the spindles. remove the upper ball joint retainer nut, loosen lower bj nut to bottom threads, smack spindle with hammer to unseat the upper. remove snap ring then pry or chisel out the cam, and install new one. http://www.therangerstation.com/tech_library/Alignment.html
For
a small yearly donation, you can support this forum and receive a 'Supporting
Member' banner, or become a 'Supporting Vendor' and promote your products here.
Click the banner to find out how.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.