• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

94 ranger 4x4 rear axle "thump" around corners


bnichols04

New Member
Joined
Sep 6, 2007
Messages
52
Reaction score
0
Points
0
Age
37
Vehicle Year
1994
Make / Model
ford
Transmission
Automatic
i am hearing a loud single "thump" noise when i turn either left or right. i jacked up the rear axle and i can duplicate the noise by pulling in and out on either the left or right rear tire. do i need to replace the axle? it seems to be more than normal movement.
 


Ranger Sport Honduras

Zoom Zoom
OTOTM Winner
Solid Axle Swap
Joined
Nov 16, 2008
Messages
15,061
Reaction score
197
Points
0
Age
37
Location
Honduras
Vehicle Year
2003
Make / Model
Mitsubishi/Ford
Engine Size
3.0/2.3
My credo
Fortune Favors the Brave
seems like the bearings are worn out.
maybe someone with more knowledge will chime in and say if this is the problem and explain how can u replace them.
 

bnichols04

New Member
Joined
Sep 6, 2007
Messages
52
Reaction score
0
Points
0
Age
37
Vehicle Year
1994
Make / Model
ford
Transmission
Automatic
it feels like the axle is moving in hitting the pin in the diff and out pulling on the c-clip. maybe the c-clip is worn out causing excessive movement??
 

Ranger Sport Honduras

Zoom Zoom
OTOTM Winner
Solid Axle Swap
Joined
Nov 16, 2008
Messages
15,061
Reaction score
197
Points
0
Age
37
Location
Honduras
Vehicle Year
2003
Make / Model
Mitsubishi/Ford
Engine Size
3.0/2.3
My credo
Fortune Favors the Brave
hmm, no i think its the bearings. at least thats what my cousin told me about his truck the other day.
 

Sunk

New Member
Supporting Member
TRS Banner 2010-2011
TRS Banner 2012-2015
Joined
Aug 19, 2007
Messages
6,657
Reaction score
125
Points
0
Age
35
Location
Everett, WA
Vehicle Year
2012
Make / Model
Ford
Engine Size
3.5 Eco
Transmission
Automatic
The c-clips do that normally. Have you checked the suspension?
 

jhammel85

Guest
I agree that it does sound like the bearings. C clips have a little bit of "play" but nothing that I've ever noticed in a turn. I bet it could do it if they were bad though..
Have you checked the bearings at all or had the diff cover open for anything else recently?
 

bnichols04

New Member
Joined
Sep 6, 2007
Messages
52
Reaction score
0
Points
0
Age
37
Vehicle Year
1994
Make / Model
ford
Transmission
Automatic
i measured the movement and it is about 1/2" of movement. i can push on the bed and rock the rear back and forth and i can get it to make the noise. i have not had the cover off before. it has the same amount of movement on both sides. the bearings don't growl or anything.
 

hondaxr650

New Member
Joined
May 21, 2010
Messages
640
Reaction score
4
Points
0
Location
Tacoma, WA
Vehicle Year
1997
Make / Model
Ford
Engine Size
4.0
Transmission
Automatic
There is always some end play on c-clip axles but the movement increases as the limited slip clutches wear and the side gears move farther outward, away from the center pin. If you really have a 1/2 inch of play, you're due for new clutch packs. I replaced some in a sport trac a couple of weeks ago with the same problem and there was not even a hint of friction material left on any of the plates. It's normal for the axles to move freely sideways in the bearings so I wouldn't be concerned about the bearings.
 

Sponsored Ad


Sponsored Ad

Staff online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Shran
April Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top