Welcome Visitor! Please take a few seconds and palsdot
New Member
- Joined
- May 2, 2016
- Messages
- 11
- Reaction score
- 0
- Points
- 0
- Transmission
- Automatic
Tested the wires going to the ECC and they looked good. I replaced the positive battery cable as it was not looking the best either. Have drove it about 20 miles and have not had the stumble issue happen again yet.
I wanted to see if the computer had thrown any codes and when I read KOEO it read an O 67. With KOER it read R41 (HEGO (HO2S) sensor voltage low / system
lean) and R21 (Cooling Temperature sensor out of specified)
range or ECT out of range?
Are these anything that I should be worried about And would they have an effect on how the motor is running?
I wanted to see if the computer had thrown any codes and when I read KOEO it read an O 67. With KOER it read R41 (HEGO (HO2S) sensor voltage low / system
lean) and R21 (Cooling Temperature sensor out of specified)
range or ECT out of range?
Are these anything that I should be worried about And would they have an effect on how the motor is running?
