84bluebronco2
New Member
- Joined
- Dec 7, 2009
- Messages
- 754
- Reaction score
- 13
- Points
- 0
- Location
- Central New York
- Vehicle Year
- 94
- Make / Model
- Ford
- Engine Size
- 4.0
- Transmission
- Manual
I'm sure this has been done a million times, but I had a bit of a rust issue...
Decided to tackle the project with a wire wheel on the end of my drill, a sandwich, and then a can of bed liner.
Once it dried, and i think it turned out well, the floor was recovered by a piece of stain master carpet pad. Possibly not the best choice, but it was on sale at Lowe's...
Put the carpet back down, and screwed on the trim.
Reloaded the back, and ready to venture off again!
And a photo op for the new hubs
Decided to tackle the project with a wire wheel on the end of my drill, a sandwich, and then a can of bed liner.
Once it dried, and i think it turned out well, the floor was recovered by a piece of stain master carpet pad. Possibly not the best choice, but it was on sale at Lowe's...
Put the carpet back down, and screwed on the trim.
Reloaded the back, and ready to venture off again!
And a photo op for the new hubs