hillvalleybronc
New Member
- Joined
- Jan 4, 2010
- Messages
- 13
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1989
- Make / Model
- ford
- Transmission
- Manual
Im swapping in a 99 ranger 4.0 motor and tranny in my 89 bronco 2. I have a few questions. I have the complete donor ranger with the 4.0. Both vehicles are manual trannys.. Questions are..Do i use the 2.9 rubber motor mounts or use the mount off the ranger.. and What all wires to I have to use to run the temp guage and oil guages etc..Also need help with the fuel system.. when takin out the 4.0 i only had to unhook the pressure side line. where is the return at and how will it line up with the factory 2.9 system. thanks for any help with this project
Last edited: