willfixx2
New Member
- Joined
- Aug 6, 2008
- Messages
- 21
- Reaction score
- 0
- Points
- 1
- Vehicle Year
- 1984
- Make / Model
- Ford
- Transmission
- Manual
I have a 2.9 that has been on an engine stand for 7 years. I removed the oil pan to check the condition back then and I'm ready to reassemble and drop it in. I think it block should be pre-oiled before an attempt to start it. Is there a way to pre-oil the motor on the engine stand. I would think any residual that might have been on the rods and rockers would have drained down in 7 years. What do you think?