Welcome Visitor! Please take a few seconds and XLTbeater
New Member
- Joined
- Nov 6, 2007
- Messages
- 69
- Reaction score
- 1
- Points
- 0
- Vehicle Year
- 1991
- Make / Model
- Ford
- Engine Size
- 4.0L
- Transmission
- Automatic
I am looking to rebuilding the front suspension on my 1991 Ranger. I was planning to do this in a year or so, but these roads after 2 bad winters have beaten the crap outta my truck. I will do as I did with my Crown Vic project and get all the pieces cleaned, painted, and all bushings installed before swapping everything over. So my question is; does my 1991 Ranger share the same twin I-beam suspension as a 1994 Explorer? I have been stripping said Explorer for engine parts. I didn't bother to check the suspension. This junkyard is pretty far from where I live, but they tend to keep the older vehicles for a little bit before crushing them. There is another junkyard a bit further away that has a 1992 Ranger, but I don't want to travel that far (especially if I find that it was crushed) if I don't have to. Thank you for any help you can give me.
XLTbeater
XLTbeater
