Welcome Visitor! Please take a few seconds and 
- Joined
- Mar 28, 2017
- Messages
- 180
- Reaction score
- 17
- Points
- 18
- Location
- MS
- Vehicle Year
- 1987
- Make / Model
- Ford
- Engine Type
- V8
- Engine Size
- 5.0L EFI
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
- Total Lift
- 4"
- Tire Size
- 31 X 10.5 X 15
- My credo
- Duty, Honor, Country
I have an 87 BII 4X4 and have swapped in a 1990 5.0L and AOD trans from a Lincoln Town Car. I currently have the Explorer cast iron manifolds installed; however, would like very much to replace them with headers. For quite some time I've searched for headers that would fit my engine/trans combo with no luck; until now.
According to L&L, their headers, model 797304, will my 87 BII 4X4 with the 5.0L and AOD transmission.
Has anyone here used these headers with a Ranger/BII 4X4 with a 302/5.0L and AOD trans? If so, did they fit well? Did they actually clear the bell housing? Were any modifications required? Finally, can they be installed with the motor already installed in the vehicle?
Thanks for any feedback.
Mark
According to L&L, their headers, model 797304, will my 87 BII 4X4 with the 5.0L and AOD transmission.
Has anyone here used these headers with a Ranger/BII 4X4 with a 302/5.0L and AOD trans? If so, did they fit well? Did they actually clear the bell housing? Were any modifications required? Finally, can they be installed with the motor already installed in the vehicle?
Thanks for any feedback.
Mark
