CraigK
New Member
- Joined
- Nov 17, 2007
- Messages
- 293
- Reaction score
- 2
- Points
- 0
- Vehicle Year
- 1987
- Make / Model
- Ford
- Transmission
- Automatic
I've posted on the main forums in the "4WD Systems" section, but am not getting any help on this specific question.
The vehicle is an 1987 Bronco II with electric pushbutton 4x4/LOW control. I have no power to my T-case controller. (I have already replaced the T-Case motor.) I do not get any clicking when I push the 4x4 or LOW buttons, and have no red light on (blinking or steady) on the controller itself when I run the diagnostic. There does not seem to be any power supply to the controller.
I cannot figure out which fuse or fusable link or whatever is supplying power to the t-case controller. I doubt it is the 5A fuse in the #17 position of the underdash fuse panel, as the amperage requirement should be 15A or 20A. I have no under-the-hood power distribution box (that I can see).
Does anyone know what fuse/wire provides power to the t-case controller on this year of BII with electric pushbutton control???
Thanks.
CraigK
The vehicle is an 1987 Bronco II with electric pushbutton 4x4/LOW control. I have no power to my T-case controller. (I have already replaced the T-Case motor.) I do not get any clicking when I push the 4x4 or LOW buttons, and have no red light on (blinking or steady) on the controller itself when I run the diagnostic. There does not seem to be any power supply to the controller.
I cannot figure out which fuse or fusable link or whatever is supplying power to the t-case controller. I doubt it is the 5A fuse in the #17 position of the underdash fuse panel, as the amperage requirement should be 15A or 20A. I have no under-the-hood power distribution box (that I can see).
Does anyone know what fuse/wire provides power to the t-case controller on this year of BII with electric pushbutton control???
Thanks.
CraigK