Welcome Visitor! Please take a few seconds and EnglishImport
New Member
- Joined
- Sep 8, 2015
- Messages
- 2
- Reaction score
- 0
- Points
- 0
- Location
- Detroit
- Vehicle Year
-
2003
1998
- Make / Model
-
Ford
Ford
- Engine Size
- 4.0
- Transmission
- Manual
Hey everyone,
I recently purchased a Mictuning led light bar from Amazon, when it arrived it was not supplied with a wiring harness. However ordeted on the next day so it would be here by the weekend.
The fun part:
The installation was more on the creative side more than anything else there really isn't a lot of room to pay with with an 8in LED light bar that makes sense. So I decided to put the light right in between my two front tow hooks. A bracket had to be made.
I simply used:
1/16in steel
Various nuts and bolts from my bolt bucket
Black plastidip
Hardware supplied with light bar
Below are the results of the fabrication and final result.
Sent from my SCH-i705 using Tapatalk
I recently purchased a Mictuning led light bar from Amazon, when it arrived it was not supplied with a wiring harness. However ordeted on the next day so it would be here by the weekend.
The fun part:
The installation was more on the creative side more than anything else there really isn't a lot of room to pay with with an 8in LED light bar that makes sense. So I decided to put the light right in between my two front tow hooks. A bracket had to be made.
I simply used:
1/16in steel
Various nuts and bolts from my bolt bucket
Black plastidip
Hardware supplied with light bar
Below are the results of the fabrication and final result.
Sent from my SCH-i705 using Tapatalk
