Welcome Visitor! Please take a few seconds and l0sts0ul
New Member
- Joined
- Jul 15, 2014
- Messages
- 50
- Reaction score
- 0
- Points
- 0
- Location
- Edmonton, AB, Canada
- Vehicle Year
- 1994
- Make / Model
- Ford
- Engine Size
- 3.0L
- Transmission
- Automatic
Hello,
I've been looking everywhere to get the measurements for the custom made mounts you can make out of the 1/4" steel.
I've tried using the transdapt mounts, and due to my oil pan or other reasons I can't seem to see, they dont' work.
I have the steel to make the mounts, I have the original ford mounts, to get the distance between the block holes, but I can't find the measurement for the distances between the mounts on the block width wise.
has anyone got this measurement, or a plan of some sort. I've tried to contact someone on another board that seems to own the prints (designer) but I Can't get ahold of him, and his mailbox is full.
thank you in advance, and I do appreciate it.
I've been looking everywhere to get the measurements for the custom made mounts you can make out of the 1/4" steel.
I've tried using the transdapt mounts, and due to my oil pan or other reasons I can't seem to see, they dont' work.
I have the steel to make the mounts, I have the original ford mounts, to get the distance between the block holes, but I can't find the measurement for the distances between the mounts on the block width wise.
has anyone got this measurement, or a plan of some sort. I've tried to contact someone on another board that seems to own the prints (designer) but I Can't get ahold of him, and his mailbox is full.
thank you in advance, and I do appreciate it.
