• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

operation of the nuetral saftey switch on an a4ld


Joined
Sep 24, 2012
Messages
432
Reaction score
1
Points
16
Vehicle Year
07/86
Make / Model
ford
Engine Size
4.0
Transmission
Manual
how does this sensor function. i traced all the wires and they dont make sense.
 


adsm08

Senior Master Grease Monkey
Supporting Member
Article Contributor
Ford Technician
TRS 20th Anniversary
Joined
Sep 20, 2009
Messages
34,623
Reaction score
3,613
Points
113
Location
Dillsburg PA
Vehicle Year
1987
Make / Model
Ford
Engine Type
4.0 V6
Engine Size
4.0
Transmission
Manual
2WD / 4WD
4WD
Tire Size
31X10.50X15
When you are in park or neutral the switch closes contacts inside of it to complete the circuit between the ignition switch and the starter relay. Then when you hit the key engine goes vroom. Simple as that.
 

RonD

Official TRS AI
TRS Technical Advisor
Joined
Jun 2, 2012
Messages
25,290
Reaction score
8,290
Points
113
Location
canada
Vehicle Year
1994
Make / Model
Ford
Transmission
Manual
There are two separate circuits in an NSS(neutral safety switch)

There is a 12volt wire that is active when key is on, this is for the reverse lights, when you shift into Reverse the switch connects the 12v wire with the wire going to reverse lights.

There is another wire from the ignition switch, it only has 12volts when Key is turned to START.
There are 1 or 2 other wires, one will go to starter relay on fender("S" terminal), 2nd wire will go to TFI module on distributor.
These 2 wires are spliced on some models so only 1 wire is on the switch.
As adsm08 said when trans is in Park or Neutral these wires will be connected thru the switch.
So when you turn the key to START, 12volts will go to the switch then to the starter relay(activating starter motor) and to the TFI module(giving 12volts to spark system).
If trans wasn't in park or neutral then 12volts would not go to starter relay or spark system.
 
Last edited:
Joined
Sep 24, 2012
Messages
432
Reaction score
1
Points
16
Vehicle Year
07/86
Make / Model
ford
Engine Size
4.0
Transmission
Manual
thanks guys. since I've traces the wires. like you said Ron there are two the go the starter switch. one wire splices into the pcm and gets power only when I turn the key to start. what is the purpose of the wire going to the pcm.

if your wondering why I'm wondering what and where these wires go. I'm concerned the neutral safety switch is the culprit to my overdrive problem
 

Sponsored Ad


Sponsored Ad

Members online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Kirby N.
March Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top