- Joined
- Jul 16, 2008
- Messages
- 291
- Reaction score
- 11
- Points
- 18
- Location
- Bridge City, Texas
- Vehicle Year
- 1996
- Make / Model
- Ford
- Engine Type
- 4.0 V6
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
Hello All-
It has been a while since I have last been here. I am in need of some information that I have had a very hard time researching. I would like to know the lift, duration and centerline of our factory 3.0 camshaft.
I am also curious whether or not anyone knows the "cc" of our factory intakes, upper and lower plenum combined without any porting or polishing.
Anyone up for an experiment? If you have an upper and lower intake handy try tilling the runners and plenum with ordinary tap water. After full, somehow pour that water into a bucket then weigh it or place in a liter bottle and post a photo or the weight. I can get a rough estimate from that information, at least close enough for government work.
Thanks to anyone who has some information or suggestions.
rob
It has been a while since I have last been here. I am in need of some information that I have had a very hard time researching. I would like to know the lift, duration and centerline of our factory 3.0 camshaft.
I am also curious whether or not anyone knows the "cc" of our factory intakes, upper and lower plenum combined without any porting or polishing.
Anyone up for an experiment? If you have an upper and lower intake handy try tilling the runners and plenum with ordinary tap water. After full, somehow pour that water into a bucket then weigh it or place in a liter bottle and post a photo or the weight. I can get a rough estimate from that information, at least close enough for government work.
Thanks to anyone who has some information or suggestions.
rob