• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

bizarre cel codes (from scanner not flashes)


nesralyrrej

Member
Joined
Jun 23, 2014
Messages
309
Reaction score
2
Points
18
Location
Arvada Crawlarado
Vehicle Year
1990
Make / Model
ford
Engine Size
4.0 s/c
Transmission
Manual
My credo
Make it fast, Make it loud.
my scanner came up with codes;

14 Profile Ignition Pickup Circuit Failure

19 Failure In PCM Internal Voltage
Erratic RPM During Hard Idle Self Test
RPM Drop Too Low During ISC Off Test (1.9L EFI)
Power Processor Check (2.3L HSC EFI)
Cylinder Identification Sensor Input Failure (3.0L SHO)

22 Manifold Absolute Pressure/Barometric Pressure Sensor Out Of Self Test Range (i believe it doesnt have a map sensor..)

23 Throttle Position Sensor Out Of Self Test Range

39 AXOD Converter Bypass Clutch Not Applying Properly (uhh front wheel drive only?)

47 4 X 4 Switch Is Closed (its 2wd)
Measured Air Flow Low At Base Idle

so um whats goin on? again this was from my very expensive scanner
 


adsm08

Senior Master Grease Monkey
Supporting Member
Article Contributor
Ford Technician
TRS 20th Anniversary
Joined
Sep 20, 2009
Messages
34,623
Reaction score
3,613
Points
113
Location
Dillsburg PA
Vehicle Year
1987
Make / Model
Ford
Engine Type
4.0 V6
Engine Size
4.0
Transmission
Manual
2WD / 4WD
4WD
Tire Size
31X10.50X15
Which engine?
 

nesralyrrej

Member
Joined
Jun 23, 2014
Messages
309
Reaction score
2
Points
18
Location
Arvada Crawlarado
Vehicle Year
1990
Make / Model
ford
Engine Size
4.0 s/c
Transmission
Manual
My credo
Make it fast, Make it loud.

kimcrwbr1

Well-Known Member
Joined
Dec 6, 2009
Messages
6,044
Reaction score
46
Points
48
Location
maplevalley WA
Vehicle Year
1983
Make / Model
ford
Engine Size
2.8l
Transmission
Automatic
Have you gone through and cleaned all the wire connectors good with electrical cleaner and put back together with dielectric grease. Sand all grounds metal to metal. Look for cracked bare or broken wires and fix as necessary. Especially around the manifold/s. Allways address the lowest number first clear the memory and reset the computer by disconnecting the battery for 1/2 hour. Any time you clean or change a senser clear the memory and reset the computer to confirm the repair.
 

nesralyrrej

Member
Joined
Jun 23, 2014
Messages
309
Reaction score
2
Points
18
Location
Arvada Crawlarado
Vehicle Year
1990
Make / Model
ford
Engine Size
4.0 s/c
Transmission
Manual
My credo
Make it fast, Make it loud.
its throwing codes for things it doesnt have
 

Sponsored Ad


Sponsored Ad

Staff online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Shran
April Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top