CarsonChris
New Member
- Joined
- Apr 1, 2011
- Messages
- 168
- Reaction score
- 1
- Points
- 0
- Vehicle Year
- 1990/87
- Make / Model
- Ford
- Engine Size
- 4.0/2.9
- Transmission
- Manual
I'm swapping in the FM-146 from A4ld. The mechanical part is done. Now it's on to the wiring.
I noticed an empty pin connector on the drivers side rail that looks like it would fit the neutral safety switch on the FM146. It's in the correct position to reach over to the transmission. Is it there or is it on the wiring harness from the A4ld with the five pin connector and the two pin connector?
The wire color of the connector on the side rail appears to be the same color as the neutral safety switch wire.
I read the tech section where people discuss wiring into the five pin connector but was wondering if this extra pin is a factory connection?
I noticed an empty pin connector on the drivers side rail that looks like it would fit the neutral safety switch on the FM146. It's in the correct position to reach over to the transmission. Is it there or is it on the wiring harness from the A4ld with the five pin connector and the two pin connector?
The wire color of the connector on the side rail appears to be the same color as the neutral safety switch wire.
I read the tech section where people discuss wiring into the five pin connector but was wondering if this extra pin is a factory connection?