Gary101386
New Member
- Joined
- Oct 26, 2011
- Messages
- 319
- Reaction score
- 1
- Points
- 0
- Location
- Oswego IL
- Vehicle Year
- 1989
- Make / Model
- Ford
- Engine Size
- 2.9
- Transmission
- Manual
I had some work done on my truck one being the 2.9-4.0 clutch conversion. now that I have it back after it warms up the trans is making a rubbing noise and when I put the clutch in its worse. also its difficult to get into 1st gear. Also, pretty much any time I put it into reverse it grinds, sometime way worse than others...
The shop that did the work, forgot I exist and screwed me over... Ive taken it to other shops and have been turned away because its an older vehicle, its modified (2.9-4.0 clutch conversion) or they want a crazy amount of money.
Any help to point me in the right direction would greatly help.
My truck is a 1989 Ranger STX 2.9v6 4x4. I believe its the mitsu trans, because the hurst shifter wouldn't fit.
Thanks!
Gary~
The shop that did the work, forgot I exist and screwed me over... Ive taken it to other shops and have been turned away because its an older vehicle, its modified (2.9-4.0 clutch conversion) or they want a crazy amount of money.
Any help to point me in the right direction would greatly help.
My truck is a 1989 Ranger STX 2.9v6 4x4. I believe its the mitsu trans, because the hurst shifter wouldn't fit.
Thanks!
Gary~