Steller
New Member
- Joined
- Feb 15, 2010
- Messages
- 6
- Reaction score
- 0
- Points
- 0
- Transmission
- Automatic
So I'm installing a 4" super lift on my 98 ranger 4x4 4.0 6cyl. Anyways It came with these 2 blocks with 2 holes one end and 1 hole/notch in the other end. They aren't mentioned in the part list nor in install. I'm not finished with the front but my best guess is they go somewhere in the rear torsion housing. I can't post link/pic from my phone so below is the address to the kit picture. Here's the blocks im talking about below the brake line brackets above the front diff side bracket in middle of the picture. Any help would be much appreciated!
http://www.superlift.com/lift-kits/4-inch-1998-1999-suspension-lift-kit.asp
http://www.superlift.com/lift-kits/4-inch-1998-1999-suspension-lift-kit.asp