Welcome Visitor! Please take a few seconds and 
85_Ranger4x4
Forum Staff Member
TRS Event Staff
TRS Forum Moderator
Article Contributor
V8 Engine Swap
OTOTM Winner
TRS 20th Anniversary
VAGABOND
TRS Event Participant
- Joined
- Aug 7, 2007
- Messages
- 32,312
- Reaction score
- 17,766
- Points
- 113
- Location
- SW Iowa
- Vehicle Year
- 1985
- Make / Model
- Ford
- Engine Type
- V8
- Engine Size
- 5.0
- Transmission
- Manual
3" BL and 31's with new replacement Explorer springs in the front and I rub on hard bumps. Gets irritating after awhile.
Cost to repair is nice, if you need a ball joint you get a balljoint, you don't need a new control arm. Wheel bearings you change the wheel bearings (if you don't grease them) as opposed to a hub assembly.
Upgrading to a D35 is a bolt in affair, you can't get that with too many other axle types either.
Cost to repair is nice, if you need a ball joint you get a balljoint, you don't need a new control arm. Wheel bearings you change the wheel bearings (if you don't grease them) as opposed to a hub assembly.
Upgrading to a D35 is a bolt in affair, you can't get that with too many other axle types either.
