Welcome Visitor! Please take a few seconds and 
ab_slack
Member
- Joined
- Oct 17, 2011
- Messages
- 755
- Reaction score
- 12
- Points
- 18
- Location
- New Joisey
- Vehicle Year
- 1987
- Make / Model
- Ford
- Engine Size
- 2.9L
- Transmission
- Manual
Looks like I finally need to pull apart my right axle shaft again as the final u-joint has gone.
Since I'll be pulling this apart, for the slide joint (not sure of proper name) on this axle shaft, what is the proper type of lube/grease that should be used.
And while I am under there I think I may drop the front drive shaft and make sure that is good because it is easy. What would be the right type of lube/grease for the driveshaft to transfer case splines?
Thanks
Since I'll be pulling this apart, for the slide joint (not sure of proper name) on this axle shaft, what is the proper type of lube/grease that should be used.
And while I am under there I think I may drop the front drive shaft and make sure that is good because it is easy. What would be the right type of lube/grease for the driveshaft to transfer case splines?
Thanks
