Denisefwd93
Well-Known Member
- Joined
- May 20, 2015
- Messages
- 2,261
- Reaction score
- 74
- Points
- 48
- Location
- South East PA
- Vehicle Year
- 1994
- Make / Model
- Ford
- Engine Type
- 4.0 V6
- Engine Size
- 4.0
- Transmission
- Manual
- 2WD / 4WD
- 4WD
- Total Lift
- stock, may get leveling springs in front "somday"
- Tire Size
- 235
this is more a rant than asking for advice,
I'm selling my 93 long bed 4.0 four-wheel drive, thisthis winter I couldn't get in the four-wheel drive after the snow is gone, then! I could get it into 4 wheel drive, now I'm trying to sell the truck and four-wheel drive won't go in again! I'm so tired of crawling under trucks! I'm ready to hit it with a hammer LOL
On the 94 supercab I haven't even attempted to play with the four-wheel drive Electronics an electric motor yet.
But, while vacuuming out the cab, I put down one of the jump seats and found the module is unplugged so I plugged it back in, that's as far as I went any advice there before I even start? Lol
Still thinking about my other discussion on using a flexible shaft to complement the shiftster.
I may just take apart a shift motor and check if that bushing on the gear is gone.. looks easy enough. (easy?) after it's out!
I'm selling my 93 long bed 4.0 four-wheel drive, thisthis winter I couldn't get in the four-wheel drive after the snow is gone, then! I could get it into 4 wheel drive, now I'm trying to sell the truck and four-wheel drive won't go in again! I'm so tired of crawling under trucks! I'm ready to hit it with a hammer LOL
On the 94 supercab I haven't even attempted to play with the four-wheel drive Electronics an electric motor yet.
But, while vacuuming out the cab, I put down one of the jump seats and found the module is unplugged so I plugged it back in, that's as far as I went any advice there before I even start? Lol
Still thinking about my other discussion on using a flexible shaft to complement the shiftster.
I may just take apart a shift motor and check if that bushing on the gear is gone.. looks easy enough. (easy?) after it's out!
Last edited: