Welcome Visitor! Please take a few seconds and 
f3joel
New Member
- Joined
- Jun 2, 2015
- Messages
- 18
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1991
- Make / Model
- Ford
- Transmission
- Automatic
I got up this morning with the intention of removing the exhaust from my 91 all the way to the manifolds, and replacing it.
Had a Gibson cat back and magnaflow direct fit cat, all the seals and what not, everything but the new walker y-pipe which was going to be delivered later today.
I had been spraying the y-pipe bolts with pb blaster for about a week.
Got 3 of the 4 bolts out pretty easily, the 4th one was rounded off so I cut and drilled it out, not too bad... was plenty of room to come from the bottom and drill what was left of the bolt out of the manifold.
So about this time Fedex shows up with the y-pipe...
Open it up and look at the nice half inch hole in it where the pipes meet...
Good times.
Had a Gibson cat back and magnaflow direct fit cat, all the seals and what not, everything but the new walker y-pipe which was going to be delivered later today.
I had been spraying the y-pipe bolts with pb blaster for about a week.
Got 3 of the 4 bolts out pretty easily, the 4th one was rounded off so I cut and drilled it out, not too bad... was plenty of room to come from the bottom and drill what was left of the bolt out of the manifold.
So about this time Fedex shows up with the y-pipe...
Open it up and look at the nice half inch hole in it where the pipes meet...
Good times.
