Edgefevah
New Member
- Joined
- Dec 21, 2012
- Messages
- 219
- Reaction score
- 2
- Points
- 0
- Location
- Calgary Alberta
- Vehicle Year
- 1993
- Make / Model
- Ford
- Engine Size
- 4.0L
- Transmission
- Manual
so guys, I got a 1986 2wd project truck. I have done the explorer axle swap on the rear end and now i want to tackle the front end.
The previous owner already put Belltech lowering beams on it. The thing that has me stumped is I can't seem to see the difference between the 95+ ranger I beams and the 88 and older I beams. Especially when looking where the ball joints are mounted.
the reason I am looking into this is because i want to upgrade to dual piston callipers. any insight on this guys?
The previous owner already put Belltech lowering beams on it. The thing that has me stumped is I can't seem to see the difference between the 95+ ranger I beams and the 88 and older I beams. Especially when looking where the ball joints are mounted.
the reason I am looking into this is because i want to upgrade to dual piston callipers. any insight on this guys?