LearjetMinako
New Member
- Joined
- Aug 6, 2007
- Messages
- 2,250
- Reaction score
- 12
- Points
- 0
- Age
- 38
- Location
- Moore, OK
- Vehicle Year
- 1996
- Make / Model
- Ford
- Engine Size
- 2.3L 140ci
- Transmission
- Manual
For those that have done them. How hard is it to change the front main seal on a 1996 2.3L engine. And since I'll be doing a clutch re-build soon, also the rear main seal too. And also while at it, replace the timing belt.
The Ranger has just started to leak from the front main seal. Its not dripping yet, but it will be shortly. I was wondering how hard of a job it will be since the 1996 has the Twin I-Beam suspension. Is possible to sqeeze enough room without lifting the engine?
The Ranger has just started to leak from the front main seal. Its not dripping yet, but it will be shortly. I was wondering how hard of a job it will be since the 1996 has the Twin I-Beam suspension. Is possible to sqeeze enough room without lifting the engine?