Welcome Visitor! Please take a few seconds and 
- Joined
- Aug 19, 2001
- Messages
- 10,754
- Reaction score
- 583
- Points
- 113
- Location
- So. Calif (SFV)
- Vehicle Year
- 1990
- Make / Model
- Bronco II
- Engine Type
- 2.9 V6
- Engine Size
- 2.9L V6
- Transmission
- Manual
- 2WD / 4WD
- 4WD
- Tire Size
- 35x12.50R15
Look in the Axles FAQ post up above. Somewhere about the middle should be some info & links about gear swapping.
Basically it's a tedious, though not overly difficult job. You'll need several special tools, good knowledge about how it works (what shims need to be swapped to effect a certain change in the gear contact pattern) and LOTS of patience. If you don't possess all of those then no doubt you're bound to end up with a disaster on your hands.
I did the gears myself on my BII years ago. I just kept reading & reading & reading until I felt comfortable enough to do it, then I read some more. Finally I procured some tools and went at it. So far I've put about 45K miles on it and haven't had any issues.
Basically it's a tedious, though not overly difficult job. You'll need several special tools, good knowledge about how it works (what shims need to be swapped to effect a certain change in the gear contact pattern) and LOTS of patience. If you don't possess all of those then no doubt you're bound to end up with a disaster on your hands.
I did the gears myself on my BII years ago. I just kept reading & reading & reading until I felt comfortable enough to do it, then I read some more. Finally I procured some tools and went at it. So far I've put about 45K miles on it and haven't had any issues.
