koths211
New Member
- Joined
- Apr 21, 2013
- Messages
- 25
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 89,95,99
- Make / Model
- ranger x3
- Engine Size
- 2.9l,4.0,2.3,3.0
- Transmission
- Automatic
Here's what I got. 89 ranger xlt ext cab 2.9 4x4 automatic
Here's what's new...or rebuilt...
Rebuilt engine. Less thank 500 miles
Rebuilt trans & t-case
New injectors
New map sensor
New 02 sensor
New fuel pump
New radiator
Cat cut off
Most sensors are new...I've done so much to it that I forget stuff...
Has good fuel pressure.
The guy it was bought from cut the wiring harness in half and butt connectors to put it back together. I started soldering them back together where they go and then shrink tubing them.
Anyways it starts hard most of the time and it will only run so long until it dies.
After it dies I have to crank on it for a minute to get it to start. Then it blows black smoke Like a diesel. And doesn't wanna move very well...
Any ideas or things to try or check...
Here's what's new...or rebuilt...
Rebuilt engine. Less thank 500 miles
Rebuilt trans & t-case
New injectors
New map sensor
New 02 sensor
New fuel pump
New radiator
Cat cut off
Most sensors are new...I've done so much to it that I forget stuff...
Has good fuel pressure.
The guy it was bought from cut the wiring harness in half and butt connectors to put it back together. I started soldering them back together where they go and then shrink tubing them.
Anyways it starts hard most of the time and it will only run so long until it dies.
After it dies I have to crank on it for a minute to get it to start. Then it blows black smoke Like a diesel. And doesn't wanna move very well...
Any ideas or things to try or check...