- Joined
- Oct 25, 2015
- Messages
- 161
- Reaction score
- 7
- Points
- 18
- Location
- Bismarck ND
- Vehicle Year
- 1987
- Make / Model
- Ford
- Engine Type
- 4.0 V6
- Engine Size
- 4.0L OHV
- Transmission
- Manual
- 2WD / 4WD
- 4WD
- Total Lift
- 4"
- Tire Size
- 32's
- My credo
- Break. Upgrade. Repeat.
Hello everyone,
I have a 1992 dana 35 ttb axle that I have been waiting to install in my vehicle. However, it has been sitting around for a couple years because I was deployed and because it does not have the gear ratio to match the rear of the vehicle. The axle splines are rusty. I ordered the correct ring and pinion and install kit today. Is this axle still usable? Should I sand down the rusty axle shafts? Should I just spray them with some grease? What will it take to use this axle assembly?
Thanks.
- Joe
I have a 1992 dana 35 ttb axle that I have been waiting to install in my vehicle. However, it has been sitting around for a couple years because I was deployed and because it does not have the gear ratio to match the rear of the vehicle. The axle splines are rusty. I ordered the correct ring and pinion and install kit today. Is this axle still usable? Should I sand down the rusty axle shafts? Should I just spray them with some grease? What will it take to use this axle assembly?
Thanks.
- Joe