I figured out that it was my battery causeing the problems, it wont hold a charge anymore. I threw my extra in and started building a push button ignition. When I had the wires ran from power to the started I touched the ends and started my truck. I went off to do some other things on my truck, came back and hooked up the switch and no start. I took the wires out of the switch and just touched the ends, and no start. When I put one of the wires on metal it sparks so it obviously has power, the other one does not so I assume it is the wire coming from the started (same color, cant tell apart in the cab,) so I am at a loss. I took a break and I am going to go back out in a bit. I hope the starter wire just came disconnected but I am not sure how that would happen because it is crimped and shrink tubed to the connecter...