• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

351w swap 1988 ranger


Bruce2

New Member
Joined
Feb 3, 2017
Messages
17
Reaction score
0
Points
0
Transmission
Automatic
I have a 1988 Ford Ranger 2 wheel drive in which I had a fuel injected 302 in it and now trying to stuff a 351w in it with an AOD transmission . I have a set of hedman headers 89500 that where on the 302 but they will not clear the steering shaft or frame rail on driver side . I have searched here for what headers to use but no sure answer I found .. so i'am asking for suggestions on what headers to use... Thanks in advance..
 


Bruce2

New Member
Joined
Feb 3, 2017
Messages
17
Reaction score
0
Points
0
Transmission
Automatic
They say the will not clear the AOD transmission since its a 164 tooth flywheel bell housing...Thanks...
 

RangerFabWorks

The O.G blackwidow67
TRS Forum Moderator
Supporting Member
V8 Engine Swap
TRS 20th Anniversary
Joined
Jan 31, 2009
Messages
5,197
Reaction score
705
Points
113
Age
32
Location
Lexington, North Carolina
Vehicle Year
1990
Make / Model
Ford
Engine Size
302
Transmission
Manual
M5OD uses a 164 flywheel and with a little massaging on the header it fits my truck.
 

Bruce2

New Member
Joined
Feb 3, 2017
Messages
17
Reaction score
0
Points
0
Transmission
Automatic
Ok thanks..I messaged Hedman headers and they had no recommendations for a header..lol
 

RangerFabWorks

The O.G blackwidow67
TRS Forum Moderator
Supporting Member
V8 Engine Swap
TRS 20th Anniversary
Joined
Jan 31, 2009
Messages
5,197
Reaction score
705
Points
113
Age
32
Location
Lexington, North Carolina
Vehicle Year
1990
Make / Model
Ford
Engine Size
302
Transmission
Manual
It's the passenger side where the starter goes that will touch with the large bell housing. Some massaging with a hammer fixes this. Driver side fits absolutely perfect.

Other headers that might fit are the headman 89500s
 

Bruce2

New Member
Joined
Feb 3, 2017
Messages
17
Reaction score
0
Points
0
Transmission
Automatic
I have a set of the 89500 hedman headers and it's a no go on the 351w...but they did work well with the 302......the drivers side header is the problem with the 89500..very tight up against steering shaft and the collector is up against the frame rail with the bottom actually almost inside the frame.
 

85_Ranger4x4

Forum Staff Member
TRS Event Staff
TRS Forum Moderator
Article Contributor
V8 Engine Swap
OTOTM Winner
TRS Banner 2010-2011
TRS 20th Anniversary
VAGABOND
TRS Event Participant
Joined
Aug 7, 2007
Messages
32,192
Reaction score
17,488
Points
113
Location
SW Iowa
Vehicle Year
1985
Make / Model
Ford
Engine Type
V8
Engine Size
5.0
Transmission
Manual

Bruce2

New Member
Joined
Feb 3, 2017
Messages
17
Reaction score
0
Points
0
Transmission
Automatic
I bought a cheap set of the tri y's off of ebay...stainless steel ones for 93 bucks, I would rather hack on a cheap set then a 200 dollar set...lol...thanks for the input guy's...
 

Bruce2

New Member
Joined
Feb 3, 2017
Messages
17
Reaction score
0
Points
0
Transmission
Automatic
Got the motor in and installed headers...had to notch the frame on passenger side and need to do some rework on the header where the collector flange is as it is up against the pan rail of the AOD transmission....drivers side went right in but have a major issue with the steering shaft....need to move the one header pipe in about an inch so it clears the shaft..
 

RangerFabWorks

The O.G blackwidow67
TRS Forum Moderator
Supporting Member
V8 Engine Swap
TRS 20th Anniversary
Joined
Jan 31, 2009
Messages
5,197
Reaction score
705
Points
113
Age
32
Location
Lexington, North Carolina
Vehicle Year
1990
Make / Model
Ford
Engine Size
302
Transmission
Manual
What engine mounts are you using?
 

85_Ranger4x4

Forum Staff Member
TRS Event Staff
TRS Forum Moderator
Article Contributor
V8 Engine Swap
OTOTM Winner
TRS Banner 2010-2011
TRS 20th Anniversary
VAGABOND
TRS Event Participant
Joined
Aug 7, 2007
Messages
32,192
Reaction score
17,488
Points
113
Location
SW Iowa
Vehicle Year
1985
Make / Model
Ford
Engine Type
V8
Engine Size
5.0
Transmission
Manual
Watch where the starter will go if you don't have the starter in too.

I tried tri-y's on my 302 and it was really really tight there with the 164t bellhousing.
 

Bruce2

New Member
Joined
Feb 3, 2017
Messages
17
Reaction score
0
Points
0
Transmission
Automatic
What engine mounts are you using?
Im using the stock 2.9 engine mounts and made adapter plates, which is the same plates that we used when we had a 302 EFI in there..

We have the tri y headers mounted...had to notch frame on passenger side and the driver side we are going to have to do some major mod's to the steering shaft to clear the headers....also since we have an AOD in it the header flanges are up against the pan rail of transmission, but we think a little heat and tweak and we will be good to go.. Had to pull heater A/C box completely out due to hardly any room at the fire wall since we have elderbrock aluminum valve covers on it, we had already modified the air box to fit the 302 in there...Trying to find an A/C delete heater box now...
 

Bruce2

New Member
Joined
Feb 3, 2017
Messages
17
Reaction score
0
Points
0
Transmission
Automatic
Here is how we dealt with the steering shaft issue...
 

Attachments

RangerFabWorks

The O.G blackwidow67
TRS Forum Moderator
Supporting Member
V8 Engine Swap
TRS 20th Anniversary
Joined
Jan 31, 2009
Messages
5,197
Reaction score
705
Points
113
Age
32
Location
Lexington, North Carolina
Vehicle Year
1990
Make / Model
Ford
Engine Size
302
Transmission
Manual
What parts did you use for the steering shaft?
 

Sponsored Ad


Sponsored Ad

Members online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Kirby N.
March Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top