KJT123
New Member
- Joined
- Jul 8, 2009
- Messages
- 6
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1998
- Make / Model
- Ford
- Transmission
- Manual
Hello all,
I had to replace my clutch/brake pedal assembly do to it being siezed up. I removed the master cylinder from the clutch and i must have done something wrong.. maybe pulled the shaft on the master cylinder too far out from the plastic peice. Now the metal rod on the master cylinder is stuck in the out position. Does anyone know if this can be pushed back in at all or fo i have to buy a new master cylinder? The metal shaft is not disconected but just wont go back in. Any help would be appreciated.
Thanks,
KJT
I had to replace my clutch/brake pedal assembly do to it being siezed up. I removed the master cylinder from the clutch and i must have done something wrong.. maybe pulled the shaft on the master cylinder too far out from the plastic peice. Now the metal rod on the master cylinder is stuck in the out position. Does anyone know if this can be pushed back in at all or fo i have to buy a new master cylinder? The metal shaft is not disconected but just wont go back in. Any help would be appreciated.
Thanks,
KJT