• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Swap 4.0 to Bronco II'88 need help


Alik_Melkor

Member
Joined
Mar 6, 2014
Messages
11
City
Elektrostal, Russia
Vehicle Year
1988
Transmission
Manual
My credo
just do it!
Hi all, last weekend I put in my Ford Bronco 2 (1988) 4.0 out of Ford Explorer OHV. the engine started, but I have not worked tachometer, I do not get it to connect, can anyone tell me how it to do?
thanks for the help
PS
I speak English not good, so say easier, please :-)
 
i believe there is a tan/yellow wire on the 4.0 harness that you need to splice with the one that runs the tach on the 2.9. I havent dont my swap yet, i start tonight. But i have also heard there is no designated wire for the tach on the 2.9 so idk how it works. Look at the schematic!
 
I have done this, and my tach does work, but I cannot remember the color of the 2.9 wire. I have been looking when I have time, and I will find this answer.

Hitchner is correct about the tan/yellow wire on the 4.0 harness.
 
thank you gues. the colour of tach i'll try to find. I've see that tan/yellow run ignition control module to PCM. just connect idm pin with tach. thanks!
excuse me for my English. if I'll have any problems in future I'll ask here:-)
 
Last edited:
Ok, I now remember why I don't have the color of the wire for the tach in the 2.9 harness. I never found or identified that wire, I found the pin on the back of the cluster and traced it's line back along the circuit board.
 
ALIK, what wires did you use to power the fuel pump, starter and main power? I have power to my dash and everything but the fuel pump wont turn on. I spliced Red/Lt Grn to Red/Lt Grn and Red/Lt Blue to Pink.
 
look at the pictures:
first: fuel pump connector whith wire from 4.0 hairnes

power for ignition and PCM, you need wire, I'm just take wire in shope and connect(let's call it "handmade")

here connect handmade wire to 4.0 hairnes


use this wire to power ignition

tаke power from this connector

power for fuel pump


if you have any question i'll try to answer
 
Last edited:

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top