Showing Visitor Messages 1 to 10 of 28
-
$50 plus shipping?
ive got a 96 ranger that i just put in a new flex plate..... after everything was installed i started it up and put in drive and i got nothing.... it like i have no gears... the trans was rebuilt about a year ago and a new torque converter was installed... i had no problems wat so ever when i put in the trans a year ago
Theres is a faint grinding noise that sound like its coming from the bell housing..... would a bad rear diff prevent the truck from moving
You commented on my thread about this. do you think replacing the torque converter would solve the issue
-
Looking for 95-98 manual trans pedal bracket. Conducting an experiment for the betterment of all Ranger-kind.
I have a manual trans pedal bracket if your still looking
-
Hello sir. I just got a 4.0 w/ 60,000 miles on it. 1994/2wd/5spd. No issues, drives like new. Just wondering your thoughts on the truck, mainly the engine.
-
Hey I see you are from Northumberland. I went to school up in PA I graduated last May from Penn College.
-
How did i get here...............ooooops! NRN noreplyneeded
-
Hey man I'm new to this forum. Pretty much never used one before. How do I post a message or thread ? To get feed back ?
-
i have a quick question do you no if the 4.10 gears out of my D35 front axle out of my 1990 will go in to my D35 front axle out of a 94? the 94 axle has 3.73 gears in it
-
hey man u got any tailights for my 91...number is 238 3982
-
Happy Birthday kiddo, have ya some fun bro!
-
Seeing that your a ford tech, I have a question for you. I hit a large rock with the side of my drivers side tire and tire hasn't been straight since. It leans in just slightly and I can't figure out why. I put a new camber kit on, which help to correct it a little, I also got new ball joints and tie rod end, replaced the broken sway bar end link and had a front end alignment. Still, not straight. When the wheel is off the hub looks slightly tilted in, but nothing looks bent to me or anyone of the shops that have looked. Could it be a blown hub or spindle? thats the last thing I could think of.