im putting an explorer shaft into my truck to get rid of the ratbagged 2 peice. its expensive to extend it so i was looking for an accurate u joint centre to centre measurement to give the driveline shop. the truck is a 92 ranger, ext cab, 4.0, 5 speed 4x4 with 1.5 inchs of lift. i tryed to get a 98 shaft but its impossible to find up here. it needs 47 inchs weld to weld but this is a sketchy measurement because im sure the explorer slip yoke is a different size so i will need the u joint center to center if anybody is sure of it, thanks
ext cab shaft length
- Thread starter gnardoom
- Start date
- Joined
- Aug 16, 2007
- Messages
- 81
- Points
- 3,101
- City
- Langford, BC, Canada
- Vehicle Year
- 1987
- Transmission
- Manual
could you not just take your truck to the driveline shop? im sure they can measure it up as well
Sponsored Ad
TRS Events & Gatherings
Latest posts
-
-
-
-
Duraflex Hood - anyone have one?- Latest: PetroleumJunkie412
-
-
-
-
-
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
