PDA

View Full Version : 1988 ranger high rider


kozina
08-24-2010, 09:57 AM
I feel kind of silly using this forum but I am trying to remove the fake wood dash trim from my sons 1988 ranger and i dont want to break it. we need to get to the back of the aftermarket radio. I dont see any screws holding the trim on.

mn_smokeater
08-24-2010, 10:19 AM
going off my experiences with a 1st Gen there could be some trim pieces that will snap off to reveal the screws holding the main pieces in

Ranger Kip
08-24-2010, 10:22 AM
I will check on my truck when I am down at the barn (2 hours I will post back).

Sunk
08-24-2010, 10:28 AM
There are 2 or 3 pieces running horizontally across the dash that need to come off. The headlight knob will need to be popped off too. Then there are a few screws and the top of the gauge surround piece toward the top of the steering wheel. They're hard to see, but you can feel them.

robertc1024
08-24-2010, 12:33 PM
+1 with Sunk. The lower dash pieces just snap straight out towards the rear of the truck. I just did this on my '88 and they're stout enough that you shouldn't have to worry too much about breaking them.

Ranger Kip
08-24-2010, 01:42 PM
yeah, what they said

kozina
08-24-2010, 05:02 PM
Thank you all....It was a success!!! great tip on the horizontal bars...Sub woofer banging away!!!! What am i getting myself into????

mn_smokeater
08-24-2010, 05:41 PM
into fun of course. good to hear its workin.