View Full Version : 96 ranger build
02-10-2010, 10:20 AM
had a skyjacker 6in stage 2 kit untill june got sick of the ttb. got a dana 44 hp cut it down.
reid high steer knuckels
4 88 gears
ox lockers front and rear
supper 88 kit
cage radius arms
cage coil buckets and shock mounts
3.5in dever springs for early bronco
sky jacker 8in coils in the rear
35in bfg km2s on 15x10 procomp rock crawlers
nothing done to the motor yet has 203000 on it and going strong. on the 3rd trans thow haha
02-10-2010, 10:23 AM
02-10-2010, 10:29 AM
motified my trany cross member just cut the end off and made this bracket.
also had to change the exaust we cut the y pipe off in front of the flang. took a piece of 3in pipe oveled it and welded it up then just welded a 3 bolt flange on
02-10-2010, 10:33 AM
exp 8.8 with 4.88s supper 88 kit and ox locker installed
02-10-2010, 10:39 AM
Damn, that's gonna be one bad truck! Awesome work man:headbang:
02-10-2010, 12:22 PM
oh the coil springs in the photos are no longer in it they where cage progressive springs as you can see not stiff enough
02-17-2010, 10:56 AM
here are some pics of my onbord air install since i made the rear ox into a air locker.
decided to mount the compressor in front of the air box its tight but should work good.
mounted my presure switch here to
02-17-2010, 10:58 AM
as for the air tank had alot of room under the bed
02-17-2010, 11:00 AM
viair makes a nice kit its the constant duty 400c compressor. works good
03-12-2010, 09:07 AM
just got my saginaw installed much easyer than i thought it would be only had to sand 2 parts of the bracket works great may have to get a shorter belt because this pump pully is about a inch higher
03-12-2010, 09:26 AM
Damn. That is a bad ass set up you have with that truck
03-12-2010, 10:18 PM
03-13-2010, 09:06 AM
got a new track bar and high steer arms on the way ill post pics of the steering when its done
vBulletin® v3.8.6, Copyright ©2000-2013, Jelsoft Enterprises Ltd.