Welcome Visitor! Please take a few seconds and 
97fordrunner
New Member
- Joined
- Aug 18, 2007
- Messages
- 810
- Reaction score
- 9
- Points
- 0
- Location
- New Richmond, WI
- Vehicle Year
- 1997
- Make / Model
- Ford
- Engine Size
- 4.0
- Transmission
- Automatic
Just wondering if you drill out the knuckle so its all the same size and then install the tie rod upside down on the top of the knuckle and tighten up the nut like normal or is there a bushing that a person needs to make to do it so it dosen't have any slop. want to get my steering set up a little better for less bumpsteer and all around better geometry. or is there a better set up that can be built.
