Welcome Visitor! Please take a few seconds and 
99RangerKrazy
Active Member
- Joined
- Aug 7, 2007
- Messages
- 1,122
- Reaction score
- 3
- Points
- 38
- Age
- 34
- Location
- Kennewick, WA
- Vehicle Year
- 1994
- Make / Model
- Ford
- Engine Size
- 4.0L
- Transmission
- Manual
Ok so I installed a new vacuum modulator on my Ranger (2.9L, 4x4, auto
A4LD). Before it was just not shifting, or it'd shift and pop out of gear and back into first. Now it'll shift and stay in gear, but to get it to shift, say from first to second, you have to rev it up, let off the gas completely, and then gas it again before it'll shift. Anyone know how I should adjust the vacuum modulator? Or what would cause this? Thanks
A4LD). Before it was just not shifting, or it'd shift and pop out of gear and back into first. Now it'll shift and stay in gear, but to get it to shift, say from first to second, you have to rev it up, let off the gas completely, and then gas it again before it'll shift. Anyone know how I should adjust the vacuum modulator? Or what would cause this? Thanks
