View Full Version : 2.9 Liter Forum
Pages :
[
1]
2
3
4
5
6
7
8
- 2.9l Faq
- 2.9L Heads
- 2.9 tick
- Sealant on ECT sensor?
- Fluctuating Oil Pressure
- IAC woes...
- alternater???
- Exhuast gasket or not to gasket
- 2.9 EGR valve tube & connector??? 1986
- Acting up, a one time thing
- 3.0L swap 2001 into a 93
- Modified 2.9 Cold run problems????
- 2.9L viberation
- 89 Ranger 2.9L
- quit runnin
- 2.9 problems
- How big does the air filter need to be?
- 2.9 ignition issues, need help!
- 88 2.9 fuel problems
- I need help with my 2.9
- 2.9 not idleing right
- scraping sound 2.9
- 2.9 and 2.8 flywheels and clutches?
- truck doesn't shut off
- 2.9L Idle Speed Problem!!!!
- porformance chips...looks fishy
- ranger vs S10
- frame modification
- 2.9 running problem in 1988 B2
- Reassembly
- 2.9 swap
- Air Charge Temperature sensor location?
- 2.9 Head Bolt Fix
- 88 Ranger starter won't work when hot
- Is it normal? fuel pump
- Low oil pressure 2.9
- Oil filter adapter questions
- 2.8 to 2.9 swap
- Coolant fan removal
- how many kilometres per letre should i be getting?
- 2,9 EGR? (split from other topic)
- 2.9 ingnition MIA
- lower intake
- What RPM's does an ARLD Ranger Run?
- carbed 2.9
- @$%$# freeze plug
- '92 2.9 won't start
- JBA Header Problem
- need help, memory not what it use to be!
- Fel-Pro part number for 2.9 leak stopping valve cover gaskets?
- fresh OH ~runs hot
- valve cover sealant-what type?
- ahh, so confused (emission control problems)
- im stumped
- Starting problems and cutting out
- Truck took a dump HELp
- 88 bronco 4x4 2.9 fuel problems?
- Should air come out of the egr small port?
- highway speed (lack of it)
- Fuel problem or Ignition?
- Pulling one!
- fuel injector help!
- 2.9 hairpuller
- Help with engine lean code
- 2.9 help, got wet, and wont idel right
- Getting hot
- 88 2.9 wont start
- heater core??
- Idle runs high on 2.9L
- Help Me Quick - Adjusting Rockers?
- 2.9 problems
- 89 2.9 starting problem
- 2.9L to early 4.0L swap really worth it?
- experience with camcraft 2.9l cam?
- '88 B2 2.9 BIG problem
- 2.9 noise
- Bad water pump?
- tech question
- Cooling System
- oil???
- Head differences
- blown bearing in block???
- No spark at coil
- 2.9 starts but wont run
- 88 ranger battery draining overnight
- Aftermarket
- front oil seal
- rough low rpm's
- Low oil pressure @ idle
- Confused.
- 2.9L Problems
- 2.9 ???? Now What
- oil filter housing?????????
- overheated??
- Dipstick!! please help!!
- 4.0 Crank in 2.9?
- M5R1 and clutch cover sheet metal for 2.9?
- 2.9 head recognition
- Where the heck is the oxygen sensor ??
- Starving For Fuel?
- help with timing my 2.9L
- 2.9 throttle body
- Rear Main Seal Help!
- Tired 2.9
- 88 No Spark
- Thermostat Housing Bolts
- Oil Pressure Loss
- 2.9l rebuild kits
- Electrical help...Please!
- oil pan
- Fuel Problems?
- Throttle position sensor ? install correctly?
- Sometimes she ticks, sometimes she don't
- AllanD, MAKG, Someone, Help!
- '89 harness to "87 chassis
- 2.9 Dosent hold fuel pressure
- fuel mixture problem?
- Starts but won't idle
- newer computer
- 92 2.9L Won't start
- I need help!!!!!
- 2.9 to 4.0
- 3.44 Liter Stroker?? Can it be done?
- Fuel System Question
- does this sound like a valve timing issue?
- IAT (intake air temp sensor)??????????
- fuel/electrical problems
- Fuel Mileage issues after swap
- Valve cover gaskets.
- High Idle
- no spark at coil??
- what engine?
- who did you get your 2.9l rebuild kit from?
- where do i begin with my problems???
- '86 B2, Hesitation during acceleration at high rpm
- runs rough, dies, wont start back up
- cold start problems
- Starter Bolt Size
- What problems with 2.9 engine
- throttle body swap...
- Crankshaft pulley 180* off?
- 2.9 pulleys
- Grounds
- Cold starts--Temp goes up high and then back to normal
- Throttle body opening and TPS adjustment?
- lifter question!!
- Smaller/lighter Power Steering Pump mount brackets?
- Emiss Light on Dash on '87
- Tried to set base ignition timing and surging
- stumbling idle
- huge oil leak!!!
- Key problem???
- Help(((my starter wont shut off)))
- Updating the 2.9L Tech Page - Suggestions Needed
- 86 died and no spark--stumped
- Upgraded my 89 TB to a an 87, which TPS to use?
- O2 Sensor & Poor Cold Idle Issues
- no spark
- 2.9 fuel pump relay location
- moisture
- bigger alternator
- hesitation after motor swap
- engine computers
- using IAC off 5.0- will it work on 2.9
- What tool to use?
- Fouling sparkplugs
- Head ID
- 2.8 with 3.8 FI
- Hot Start Problem
- Check Oil Light
- Pinging under medium to heavy throttle
- intake porting does it help
- 2.9 5 spd tranny problems
- 2.9 High Idle and Revs
- is the transmission safety neutral safety switch necessary
- ranger runs hot
- Please Help!!!!
- does this proglem pertain to the 2.9, too...
- need sum info and help..
- Tips on changing the Ignition Module
- Engine died....
- 2.9 help
- Weird Drivibility Problem... what else can i check??
- New 2.9L Owner
- stupid tick or knock
- Ignition trouble with a 2.9
- Idle Problem
- main bearing torque spec
- Hard to start but runs fine
- help me out please
- Electrical problem
- Aftermarket 2.9 camshaft
- Engine copartment
- 2.9 rebuild Perfomance?
- Wouldn't go and won't start
- new 2.9
- setting throttle position sensor for correct voltage
- 2.9 Idle Problems
- Problems with Ranger
- milky white oil in valve cover
- Ranger overheats while wheeling
- Pulling out a 2.9 help.
- another makg or allen d question
- Engine Won't Start
- Help, trying to remove fpr
- Irritating tick
- air charge temp sensor
- Where is the diagnostic port located?
- help
- is Lucas Oil Stabilizer any good to add to a 2.9's engine oil
- Milk Shake
- is a harbor freight fuel injection pressure tester accurate enough for testing a 2.9
- Electrical Issue
- i need a replacement 2.9
- Pulling fault codes
- Valve cover gaskets- i need advice
- Help please
- truck started to run rough....
- will a Mallory or Accel Performance ignition module, give a 2.9 more performance
- oil pump shaft
- Pulling codes - having trouble
- I need some help solving some codes
- Fuel return line
- 2.9l timing and body lift question..
- somthings over heating?
- Emissions problem with a 1987 2.9 v6.
- idles too fast with the air charge sensor connected
- distributor questions
- 2.9 B2 Serpentine Belt Conversion
- wiring diagram for 85 2.9
- Fan clutch thread snapped off......HELP!!!!
- Chrome valve covers?
- Truck running rough and exhaust note changed, where to look?
- No Spark to ground side of coil
- 87 Ranger 2.9 Leaking a bit of coolant
- what functions does the 2.9's ignition module control
- will using lucas oil stabilizer make a 2.9 harder to start at 25 below zero or colder
- cracked heads?
- 2.9 rebuild inprocess
- How to remove harmonic balancer....
- No Spark
- Help with oil pressure sending unit?
- Air Filter Box is held together by tape!
- bad thermostat?
- performance heads
- failing emissions test
- Gave the truck a tune up.
- Swapping a 2.9 to a 4.0?? The Stronger motor?
- 1987 2.9 owner worried about possible cracked heads!
- 91 in 86...Questions
vBulletin® v3.6.8, Copyright ©2000-2009, Jelsoft Enterprises Ltd.